Long water pumps were used on most 1969 and later passenger cars and 1973 and later trucks. Check your application before ordering.

Water Pump Dimensions PDF

Street Rod
This bracket is designed to be used with the factory alternator mount, eliminating the need to purchase both brackets.  The compressor belt runs in the factory A.C. groove and the bracket is complete with idler assembly.

Bracket Dimensions

Bracket Requirements

Low Profile
Engineered for low hood applications.  Works great on any vehicle with a wide engine compartment - Trucks, 50-60's cars, etc.  Bolts to the heads and water pump. WILL WORK with  factory power steering pump.

Bracket Dimensions

Bracket Requirements

Low Profile
Designed for cars with low hood clearance - Camaros, Chevelles, etc. Works on any vehicle with wide engine compartment. Bolts to head and water pump.  Works with factory alternator and power steering pump.

Bracket Dimensions

Bracket Requirements

Mid Mount
This bracket mounts the alternator just above the pump inlet. Bolts to head and water pump.  Works well in low hood applications. FITS LONG PUMP ONLY.

Bracket Dimensions

Bracket Requirements

Low Mount
Designed to mount the alternator low on the driver's side.  Bolts to the block and water pump.  Will fit narrow frame applications. Check Bracket Dimensions before ordering.

Bracket Dimensions

Bracket Requirements

Power Steering
This bracket bolts to the front of the block and water pump boss. Mounts the pump in approximately the same position as the factory bracket. Provides clearance for steering gears, etc.

Bracket Dimensions

Bracket Requirements

Power Steering (Type II Saginaw)
This bracket is designed to be used with the metric G.M. remote reservoir type 2 pump. Designed for street rod applications, it sits high enough to clear most chassis parts and steering gears. WILL NOT WORK WITH LOW PROFILE BRACKETS. Pump is driven off the inner groove of a 3 groove crank pulley. Pump uses an aluminum V-belt pulley available from us or other street rod suppliers.

Bracket Dimensions

Bracket Requirements

Power Steering (Type II Saginaw)
This bracket is designed to be used with the metric G.M. remote reservoir type 2 pump. Designed for low profile bracket applications, it provides clearance for alternator belt no matter where the alternator is mounted. Pump is driven off the inner groove of a 3 groove crank pulley. Pump uses an aluminum V-belt pulley available from us or other street rod suppliers.

Bracket Dimensions

Bracket Requirements

Back to Top